Janome memory craft 4900 - BLIND HEM; Blind Hemming Process and Needle Position

www.toews.com
54
START
STOP
To sew a shorter darning
To sew a darning shorter than 2 cm (3/4˝), first stop the
machine after sewing the required length, then press the
reverse button.
The required length has been determined.
Restart the machine and continue sewing until the machine
stops automatically.
q Required length
w Starting point
e Reverse stitch button
To sew the same size darning
Simply restart the machine to sew another darning at the
same size.
To sew the darning at a different size
Press the memory key and start sewing from the begin-
ning.
e
q
w
zx
To adjust the evenness of darning
The evenness of darning may vary depending on the
sewing conditions, such as type of fabrics, number of
layers etc. You can correct the unevenness of darning with
the stitch length adjustment button.
z If the left corner is lower than the right side, press
“–“ to correct it.
x If the right corner is lower than the left side, press
“+“ to correct it.
NOTE:
The evenness can be adjusted within d1 to d9 (default
setting is d5).
Janome Memory Craft 4900 Instruction Manual
Janome Sewing Machine 4900
www.toews.com
MC4900 Owners Manual/ User Guide