Janome Memory Craft 6650 - Attaching Special Presser Feet; Professional Grade Foot HP (Option); Darning Foot PD-H

u
r
t
y
z
c
v
x
q
w
e
14
CAUTION:
To avoid damaging the lever, do not push it down.
Replacing the Presser Foot
CAUTION:
Always make sure to press the lockout key to before
replacing the presser foot.
Use the proper foot for the selected pattern.
The wrong foot can cause the needle to break.
z Raise the needle by pressing the needle up/down key.
Press the lockout key.
q Needle up/down key
w Lockout key
x Raise the presser foot lifter.
e Presser foot lifter
c Press the black lever on the back of the foot holder.
The presser foot will drop off.
r Lever
v Place the presser foot so that the pin on the foot lies
just under the groove of the foot holder.
Lower the presser bar to lock the foot in place.
Each foot is marked with an identication letter.
t Pin
y Groove
u Identication letter