14
TO CHANGE FRONT PANEL (“A” BOARD UNIT) 1
TO REMOVE
1. Remove top cover, belt cover and bed cover (see page 3, 4, 5),
2. Disconnect the LCD connector from inverter and remove it from cord guide.
3. Remove screw A and loosen screws B, C, D.
4. Pull out 17 connectors form the printed circuit board (“A” board) and printed circuit board
(“F” board).
Remove the front cover unit.
NOTE: Pull out the LCD connector at the beginning to prevent damages.
TO ATTACH
5. Follow the above procedure in reverse.
NOTE: After attaching the front cover (“A” board unit), shift the bobbin winder spindle to check
the micro switch movement.
To Next Page
Loading...
