18
TO CHANGE DC MOTOR AND BELT TENSION ADJUSTMENT
TO REMOVE
1. Remove the belt cover (see page 4).
2. Pull out the plug connector from “A” board unit and remove 2 screws. Then remove the
lamp switch fixing plate.
3. Pull out the motor connector from “A” board unit and remove 2 screws. Then remove the
DC motor unit.
TO ATTACH
4. Pass the motor cord under the arm lib, then attach the motor with 2 screws temporary as
shown below,
5. Set the motor unit with the motor belt. Make sure the belt tension should be set as shown
below.
6. Attach the lamp switch fixing plate with 2 screws.
7. Insert the connectors to the “A” board unit.
8. Attach the belt cover.
To Next Page
Loading...
