Janome MEMORY CRAFT 9000 - To Change the Face Plate and Top Cover

3
TO CHANGE THE FACE PLATE UNIT AND TOP COVER UNIT
FACE PLATE UNIT
TO REMOVE
1. Remove the two screws, and remove the face plate.
TO ATTACH
2. Tighten the two screws slightly, and attach the face plate.
3. Close the face plate, and check the unevenness between The face plate and arm. Tighten
the screws securely.
4. Check if the face plate opens and closed smoothly. Adjust the position of the face plate
spring if necessary.
TOP COVER UNIT
TO REMOVE
1. Remove the two screws A and raise the handle. Then remove screw B.
2. Close the top cover and raise the handle. Then pull out the top cover unit in the direction
of the arrow.
TO ATTACH
3. Raise the handle and insert the top cover unit from the rear side.
4. Attach the top cover unit by tightening the two screws A and B.