23
TO ADJUST PRESSER FOOT SENSOR (2)
7. Set the presser dial at “2.”
8. Aft ach embroidery foot “P” and lower the presser foot slowly.
9. Turn the hand wheel toward you to bring the needle bar to its highest position.
10. Watch The LCD screen while moving the shielding plate along the free play.
LCD shows:
OPEN only correctly adjusted. Turn the power off to exit adjusting mode.
CLOSED Adjust the presser bar height with the embroidery foot and repeat steps 1-6 again.
NOTE: Lower the presser foot and turn the hand wheel while the needle position is at highest,
lowest and highest needle position, in this condition The LCD indication should be
shown “OPEN.” If LCD changes from “OPEN” to “CLOSED,” adjust the presser foot
height with the embroidery foot “P,” and repeat 1-6 adjustment.
To Next Page
Loading...
