.
Bobbin Windins
@
For horizontal
spool
pin
@
For
additional spool
pin
O
Pullthe handwheel out to the right.
@
Draw thread from
the spool.
O
Guide the thread around the thread
guide.
@
Thread through the hole in the
bobbin from the
inside to the outside.
@
Put the
bobbin on
the
bobbin winder spindle.
@
Push the bobbin to the right.
O
With free end
of
the thread
held in
your
nano,
depress
the foot
control. Stop the machine
when it has
made a few turns and cut the thread
close to the hole in the bobbin.
@
Depress the foot control again. When the
bobbin
is fully wound, it stops automatically. Return
the
bobbin winde|to its original
position
by moving
the spindle to the left and
cut
the thread
as
shown.
@
Push the handwheel in. The machine will not
function untilthe clutch is engaged.
NOTE: Position
of
lhe
bobbin winder stopper is
adjustable for the required amount of
thread
on the bobbin
(example
1/2 full or
fulletc.).
Use a screwdriver and loosen the
screw
one turn or less so that
you
can adjust the
position
of the bobbin winder
stopper.
Do not lake
out the screw all the way.
at
ai
i ,6\
J F-\-'
l4r ls)
i\
?<
-se9
@
----=Tt
ll
-1
tl
(\I---R
11
To Next Page
Loading...
