Janome MS 2028 - Getting Ready to Sew; Adjusting Straight Stitch Tension

.
Removing the Hook Cover
Plate
O
Hook cover
plate
release button
@
Hook cover
plate
Slide
the hook cover
plate
release button
O
to the
right, and
remove the cover
plale
e).
.
Inserting the Bobbin
O
End of thread
@
Notch
O
Notch
@
Threading chart
E
Place a bobbin
in the bobbin holder with the
thread running off
counterclockwise.
E
Guide the
thread into the notch
@
on the front
side of the bobbin
holder. Draw the thread to the
left, sliding it between
the tension spring blades.
E
Continue to draw the
thread lightly until the
thread slips into the nolch
€).
Pull out about 6-
(15
cm) of thread.
tr
Attach the hook
cover
plate.
by referring to the chart
@
cover
plate.
Checkthe
threading
shown
on the hook
tr
l
tr