Janome stirling - Presser Foot Operations; Presser Foot Lifter; Changing the Presser Foot; Foot Holder Attachment

14
AFTER SALES SUPPORT
AUS Hotline Costs
1300 526 663
AUS
enquiries@esqaustralasia.com.au
MODEL: 311 PRODUCT CODE: 52829 04/2016
q
Presser Foot Lifter
(Fig. 1)
The presser foot lifter raises and lowers the presser
foot.
You can raise the foot about 0.6 cm (1/4˝) higher
than the normal up position for easy removal of
the presser foot, or to help you place thick material
under the foot.
q
Presser foot lifter
w
Normal up position
e
Highest position
e
w
q
(Fig. 1)
e
w
(Fig. 2)
Changing Presser Foot
(Fig. 2)
q
Presser foot
w
Groove
e
Pin
•Toremove
Turn the handwheel toward you to raise the
needle bar to its highest position.
Raise the presser foot.
Push the toe of the presser foot q to snap it off
the foot holder.
•Toattach
Place the presser foot so that the pin e on the
foot lines up directly below the groove w of the
foot holder. Lower the foot holder to lock the foot
in place.
CAUTION:
When attaching or removing presser foot, turn
OFF the power switch.
(Fig. 3)
q
w
q
e
To Attach and Remove the Foot Holder
(Fig. 3)
q
Thumb screw
w
Foot holder
e
Presser bar
•Toremove
Remove the thumb screw q by turning it
counterclockwise with a screwdriver.
•Toattach
Match the hole in the foot holder w with the
threaded hole in the presser bar e. Fit the thumb
screw q into the hole. Tighten the screw q by
turning it clockwise with screwdriver.