q
Pattern selector: C
w
Presserfoot: Zigzagfoot
e
Thread tension: 3–7
r
Stitch length: Any
t
Darning plate
Sewing Buttons
Attach the darning plate. Match the holes in the
buttonwiththehorizontalslotonthepresserfoot.
Adjust the stitch width matching the distance of
the holes in the button. Lower the foot to hold the
button in place. Check to see if the needle enters
into the holes in the button by turning the handwheel
by hand. Sew about ten (10) stitches.
To strengthen the shank, cut the threads leaving
about 4.0˝ (10.0 cm). Bring the needle thread down
through one of the holes in the button and wind it
around the shank. Bring the needle thread to the
wrong side (bottom side) and knot.
After button sewing is completed, remove the
darning plate.
t
w e
q
r
(Fig. 3)
To Next Page
Loading...
