Janome stirling - Thread Tension Adjustment; Drawing Up Bobbin Thread; Thread Tension Dial

19
AFTER SALES SUPPOR
T
AUS Hotline Costs
1300 526 663
AUS
enquiries@esqaustralasia.com.au
MODEL: 311 PRODUCT CODE: 52829 04/2016
q
e
r
w
t
y
Thread Tension Dial
(Fig. 2)
•Correcttension
The thread tension is adjusted depending on the
sewing materials, layers of fabric and sewing
method.
 Foranidealzigzagstitch,thebobbinthread
does not show on the right side (top side) of the
fabric, and the needle thread shows slightly on
the wrong side (bottom side) of the fabric.
q Needle thread (Top thread)
w Bobbin thread (Bottom thread)
e Right side (Top side) of fabric
r Wrong side (Bottom side) of fabric
t Thread tension dial
y Setting mark
•Needlethreadtensionistootight
When the bobbin thread (bottom thread) appears
on the right side (top side) of the fabric, loosen
the needle thread tension by moving the dial to a
lower number.
•Needlethreadtensionistooloose
When the needle thread (top thread) appears on
the wrong side (bottom side) of the fabric, tighten
the needle thread tension by moving the dial to a
higher number.
z
x
c
Drawing Up Bobbin Thread
(Fig. 1)
z Raise the presser foot and hold the needle
thread lightly with your left hand.
x Turn the handwheel slowly toward you with
your right hand until the needle goes down and
continue turning the handwheel until the take-
up lever is at its highest position.
Lightly draw up the needle thread forming a
loop of the bobbin thread.
c Pull 10 cm (6˝) of both threads back and under
the presser foot.
(Fig. 1)
(Fig. 2)