Jasic EVO 2.0 EM-160C - Spool Gun Operation

45
SPOOL GUN OPERATION
Before starng any welding acvity ensure that you have suitable eye protecon and
protecve clothing. Also take the necessary steps to protect any persons within the welding
area.
Spool Gun Welding Mode
The Jasic EVO EM-160 & EM-200C machines can both be used with our
oponal spool gun which is a Euro style spool gun that connects to the
EVO MIG machines via the Euro outlet connector.
Connect the spool gun Euro plug to the (MIG) euro socket. Connect the spool
gun 9 pin control plug to its matching 9 pin socket located on the front panel of
the machine.
Ensure the trailing lead is connected into the “+” socket on the front panel of
the machine and ghten clockwise.
Insert the cable plug for the work clamp into the “-” socket on the front panel of the welding machine
and ghten clockwise.
Connect the gas hose to the regulator/owmeter located on the shield gas cylinder and connect the
other end to the machine.
Before starng any welding acvity ensure that you have suitable eye protecon and protecve
clothing. Also take the necessary steps to protect any persons within the area.
Aer connecng the welding leads as detailed above you will need to switch the power
switch on the back panel to “ON”, select MIG welding mode ‘A’ and spool gun mode ‘B’.
Set the welding voltage and other parameters via the machine control panel
When the remote control funcon is enabled, the "Wire Feed Speed" is adjusted by the
potenometer on the spool torch handle.
Ensure you have adequate welding current according to the thickness of the work and
weld prep being carried out.
Fit a 1Kg reel of welding wire to the spool holder and feed the wire through the drive rolls ensuring the
ed roller sizes matches your wire type and size, then connue to feed the wire through the contact p
again ensuring you have the correct size p ed.
Open the gas valve of the cylinder, press the torch trigger and adjust the gas regulator to obtain the
desired ow rate.
Pressing the spool gun torch trigger will start the machine and welding can now be carried out.
Adjust the “voltage” control knob on the front panel of the machine to set the correct welding voltage
and adjust the “wire feed speed” control knob on the spool gun.
Please Note:
• The spool gun opon can only be used in standard MIG welding mode, all other funcons work as
standard MIG torch. Spool gun part number is JE-SP250-6.
• MIG Synergic funcon is disabled when the control panel is set to spool gun.
If there is no wire feed potenometer built into the spool torch and Spool gun is selected and
remote control funcon is enabled, then welding current will not be able to be adjusted.
Spool gun part number is JE-SP250-6