Jasic EVO 2.0 EM-160C - Installation

16
INSTALLATION
Installaon
The owner/user are responsible for installing and using this welding machine according to this operang
manual.
Before installing this equipment, the owner/user shall
make an assessment of potenal hazards in the
surrounding area.
Unpacking
Check the packaging for any signs of damage.
Contact your supplier in the rst instance if any item
is missing or damaged. Carefully remove the machine
and retain the packaging or at least unl the
installaon is complete.
Liing
The Jasic EM-160C or EM-200C do have an integrated handle for easy hand liing only. Always ensure
the machine is lied and transported safely and securely.
Locaon
The machine should be located in a suitable posion and environment. Care should be taken to avoid
moisture, dust, steam, oil or corrosive gases. Place on a secure level surface and ensure that there is
adequate clearance around the machine to ensure natural airow. Do not use the system in rain or snow.
Posion the welding power supply near an appropriate power point ensuring you leave at least 30cm of
space around the machine to allow for proper venlaon.
Always place the machine on a rm level surface before using, ensuring it cannot p over. Never use the
machine on its side.
Most metals including stainless steel can give o toxic fume when welded or cut.
To protect the operator and others working in the area its important to have adequate venlaon in the
work area to ensure air quality level meets all local and naonal standards.
Warning!
The following operaon requires sucient professional knowledge on electric aspects and
comprehensive safety knowledge. All connecons shall be made with the power supply
turned o. Incorrect input voltage may damage the equipment.
Electric shock may cause death; aer switching o the machine, there are sll high voltages within
the machine, so if removing the covers do not touch any of the live parts on the equipment for at
least 10 minutes. Never connect the machine to the mains supply with the panels removed.
The electrical connecon of this equipment shall be carried out by suitably qualied personnel
and these shall be made with the power supply o. Incorrect voltage may damage the equipment.
Input power connecon
Before connecng the machine you should ensure that the correct supply is available.
Details of the machine requirements can be found on the data plate of the machine or in the technical
specicaon table shown on page 13 within this manual.
This equipment should always be connected by a qualied competent person.
Always ensure the equipment is correctly grounded.