Page 27
g. Selection of push/push-pull/spool torch
In MIG mode, press the corresponding function switching key to select the push torch or
spool torch.
1) If the indicator is on, it indicates that the MIG is in push torch state.
2) If the indicator is on, it indicates that the MIG is in push-pull torch state.
3) If the indicator is on, it indicates that the MIG is in spool torch state.
h. Selection of remote control function
1) Enable/disable remote control function
(1) Before welding, press the remote control function key to enable/disable the remote
control function.
(2) If the indicator is on, it indicates that the remote control function has been enabled. If it
is off, it indicates that the remote control function has been disabled.
2) Wired remote control and wireless remote control
The remote control function is divided into wired remote control and wireless remote control.
Setting method: Enter the Welding Engineer Mode (see section 6.4 for details), set the "F09"
parameter value, "1" indicating wired remote control and "0" indicating wireless remote
control.
3) Connect/disconnect wireless remote controller
(1) Connect wireless remote controller
When not welding and the wireless remote control function has been enabled, press and hold
the remote control function key on the panel and the pairing key of the wireless
remote controller at the same time for 2s to pair the wireless remote controller. During pairing,
the blue indicator of the wireless receiver module will flash. After successful pairing, the
remote control mode indicator will be on, the blue indicator on wireless receiver
module will remain on and the welder display window will display "OK".
To Next Page
Loading...
