What to do if welding current reduces when welding with Jasic Welding System?
If the welding current reduces while welding with your Jasic Welding System, it could be due to a poor work lead connection to the work piece. Ensure a proper connection of the work lead to the work piece.
How to fix no high frequency produced by Jasic Welding System?
If your Jasic Welding System is not producing high frequency, check the following: * The process select switch may be set to manual metal arc (MMA). Set the process select switch to the appropriate setting. * The torch trigger switch lead may be disconnected or faulty. Reconnect or replace the faulty torch trigger switch lead. * The high-frequency spark gap may be too wide or short-circuited. Adjust the high-frequency spark gap.
Why is there excessive spatter in MMA welding with my Jasic TIG Welding System?
If you're experiencing excessive spatter in MMA welding with your Jasic Welding System, the output polarity connection might be incorrect. Try exchanging the polarity.
What to do if the Jasic Welding System fault LED is ON and the fan is running?
If the fault LED is illuminated and the fan is operational on your Jasic Welding System, it could be due to overheating protection. Allow the machine to cool down. Also, verify the incoming mains supply voltage to ensure it is within 230V +/- 15%.
What to do if the fault LED is ON and the fan is running on my Jasic Welding System?
If the fault LED is ON and the fan is running on your Jasic Welding System, it could be due to these reasons: * The machine might be under over-heating protection. In this case, it will recover automatically after the welding machine has cooled down. Allow the machine to cool down. * The incoming mains supply might be outside the acceptable voltage range. Check the incoming mains supply to ensure it is within 230V +/- 15%.
Why does the TIG electrode melt when striking an arc with my Jasic Welding System?
If the TIG electrode melts when you strike an arc with your Jasic Welding System, it's likely because the TIG torch is connected to the (+) VE terminal. Re-connect the TIG torch to the appropriate terminal.
What to do if the Jasic Welding System power LED is OFF and the fan isn't working?
If the power LED is off and the fan isn't running on your Jasic Welding System, it could be due to several reasons: * The primary supply voltage might not be switched ON, or the input fuse may have blown. Ensure the power supply voltage is switched ON and replace the blown input fuse, if necessary. * The welding power source input switch could be switched OFF. Turn ON the welding power source input switch. * There might be loose internal connections. Check and secure any loose internal connections.
Why does the electrode holder become very hot when using Jasic TIG?
If the electrode holder becomes very hot while using your Jasic Welding System, it's likely that the rated current of the electrode holder is smaller than its actual working current. Replace it with a higher rated current capacity holder.
What causes no high frequency production in Jasic TIG Welding System?
If your Jasic Welding System isn't producing high frequency, it could be due to several reasons: * The process selector switch might be set to manual metal arc (MMA); set it to the correct position. * The torch trigger switch lead could be disconnected, or the switch/lead may be faulty; check the connection and functionality. * The high-frequency spark gap may be too wide or short-circuited; adjust it appropriately.
Why does the welding current reduce when welding with my Jasic Welding System?
If the welding current reduces during welding with your Jasic Welding System, it could be due to a poor work lead connection to the workpiece. Ensure a solid connection of the work lead to the workpiece.
General| Output Current Range | 10-200A |
|---|---|
| Welding Type | TIG |
| Frequency | 50/60 Hz |
| Protection Class | IP21S |
| Insulation Class | F |
| Duty Cycle | 60% |
To Next Page
