Why is it difficult to ignite the arc on my Jasic Welding System?
If you're finding it difficult to ignite the arc on your Jasic Welding System, the arc ignition current may be too low, or the arc ignition time may be too short. Adjust the arc ignition current and time settings.
Why is there no gas flow when the TIG torch trigger switch is depressed on my Jasic Welding System?
If there's no gas flow when you depress the TIG torch trigger switch on your Jasic Welding System, consider the following: * The gas cylinder may be empty, in which case you should replace or refill it. * The gas regulator might be turned off; turn it on. * The gas hose could be blocked or cut; inspect and repair or replace it. * The torch trigger switch lead may be disconnected, or the switch/lead could be faulty; check the connection and functionality.
What to do if the Jasic TIG Welding System power LED is OFF and the fan is not functioning?
If the power LED is off and the fan isn't working on your Jasic Welding System, first ensure the main power supply is switched ON and check/replace the input fuse. Also, verify that the welding power source input switch is ON. Finally, check and secure any loose connections internally.
How to fix excessive spatter in MMA welding with Jasic TIG?
If you're experiencing excessive spatter during MMA welding with your Jasic Welding System, the output polarity connection may be incorrect. Try exchanging the polarity connection.
Why does the TIG electrode melt when arc is struck with my Jasic TIG?
If the TIG electrode melts when striking an arc with your Jasic Welding System, it's likely that the TIG torch is connected to the (+) VE terminal. Reconnect the TIG torch to the correct terminal.
General| Output Current Range | 10-200A |
|---|---|
| Welding Type | TIG |
| Frequency | 50/60 Hz |
| Protection Class | IP21S |
| Insulation Class | F |
| Duty Cycle | 60% |
To Next Page
