Javo Plus M2.0 - Operating the Machine; Starting the Machine; Stopping the Machine; Emergency Stop

User manual for Javo Plus M2.0
Version 22300779
page 21 / 27
6. Operatingthemachine
Follow all the instructions given in this manual, in particular the instructions in the Safety Section.
Keep hands, hair, loose clothing and/or jewelry, etc., clear of moving parts of the machine. Wear suitable
garments without loose parts. Wear suitable work shoes.
Do not remove any connections or guards while the machine is turned on. The machine may be used only when
all protective devices and safeguards are correctly tted and ready for use.
Halt the work immediately when part of the machine is damaged or is not working properly. The machine may
be restarted only once the machine part has been repaired or replaced and inspected. Consult your supplier if
the machine is not working properly.
6.1. Startingthemachine
Startprocedure:
1. Turn the main switch (E) on the electrical cabinet to on.
 a.The“Stopped/error”lamp(D)lights.
2. Turnthedrill,elevatorandpottrackswitches(A+B+C)ontheelectrical
cabinet to ON.
3. Press the blue reset button (C) until the lamp lights.
4. Press the green pushbutton (B) to start the machine.
6.2. Stoppingthemachine
Stopprocedure:
1. Press the red stop button (A) on the control panel.
 a.Thered“Stopped/error”lampontheelectricalcabinetlights.
6.3. Emergencystop
Emergencystopprocedure:
1. Press the red emergency stop button (D) to activate an emergency stop.
Restartingthemachineafteranemergencystop:
1. Make sure that the reason for the emergency stop has been resolved.
2. Closeallhatchesandtallcovers.
3. Reset the emergency stop button by pulling the red head of the button out.
4. Press the blue reset button.
5. Press the green pushbutton on the control panel to start the machine.