JAYCO TOWABLE SECTION 8-PLUMBING SYSTEMS
You can locate many dump stations throughout the United States and Canada in
Woodall’s, Rand McNally Camp Guide, Good Sam Camp Guide, KOA Kampgrounds
Camp Guide and various other publications. Some fuel stations also have dump stations.
Please contact your RV dealer for assistance in the purchase and installation of a sewer
hose or sewer hose extension (if needed).
Sewage (black) tank preparation:
1. Release one to two quarts (1 or 2 liters) of water into the toilet bowl.
2. Follow the directions on your (RV approved) toilet chemical bottle (customer
supplied), by placing the recommended quantity of holding tank chemical into the
toilet bowl.
3. Flush the toilet and allow at least two gallons (8 liters) of water to flow into the
holding tank.
Waste (grey) holding tank preparation:
No special preparation is required, however, placing a small quantity of chemicals into this
tank, such as baking soda or an approved RV chemical, will reduce odors from food
particles in the system.
Cleaning & Maintenance:
The toilet should be cleaned regularly for maximum sanitation and operational efficiency.
Use only RV approved chemicals. Do not use chlorine (undiluted) or caustic chemicals,
such as laundry bleach or drain opening types, in the toilet system. These products damage
the seals in toilets and dump valves.
BLACK TANK FLUSH
The Sewer Tank Flusher Inlet (also known as the No Fuss Flush) will be located on the
utility center panel. This inlet is provided to assist in flushing out the black water tank. The
drain valve for the black water tank must be OPEN to use this feature. When the hose
is connected, and when the water source is turned on, it sprays water into the black water
tank, which aids in moving out the waste and cleaning the interior of the tank.
Using the Tank Flush Inlet:
1. Connect the flexible sewer hose to the 4 inch dump outlet.
2. Open the black water dump valve and leave it open. Allow the tank to drain.
3. Attach a water hose to the Tank Flush Inlet. Do not use your fresh water hose for
this.
4. Attach the other end of the water hose to a pressurized water source. (40 PSI
minimum)
5. Turn ON the water source flushing the tank until water appears to run clear in the
sewer hose.
6. Turn water source OFF. Disconnect water hose from the source.
7. Disconnect water hose from the Tank Flush Inlet.
8. Close the black water dump valve.
WARNING
It is important to add enough water to prevent solid waste buildup. Follow the
directions listed below and in the manufacturer’s operator manual.
8-32
To Next Page
Loading...
Need help?
General
