JAYCO TOWABLE SECTION 8-PLUMBING SYSTEMS
4. Turn the pump switch ON.
5. Fresh water tank should begin drawing solution out of the container. To aid
siphoning place the container on a surface approximately 2 feet off the ground.
6. Continue pumping until solution is drawn out of the container, or tank is at the
desired level.
7. Turn the pump Switch OFF.
8. Disconnect the garden hose from the City Water Fill inlet on the Utility Center.
“DRY CAMPING” (Pump supplies water from the fresh water tank):
1. Make sure the fresh water tank has an adequate supply of water.
2. Set the colored valves to the DRY CAMPING setting:
(A) White handle pointing right
(B) Blue handle pointing down
(C) Black handle pointing down
(D) Red handle pointing up
(E) Green handle pointing up
3. Turn the pump switch ON.
4. Water should be available to all fixtures now.
5. Turn pump OFF when water is not being used.
NOTE: To fill the fresh water tank without a pressurized water source, refer to
SANITIZE (Siphon Fill) section above, and use a container holding fresh potable water
and a hose. Water will be drawn into the tank by the pump. There is no gravity fill inlet on
the recreation vehicle.
“CITY WATER” (Pressurized fresh water source)
1. Connect the fresh water hose to the City Water inlet.
2. Set the colored valves to the CITY WATER setting:
(A) White handle pointing right
(B) Blue handle pointing down
(C) Black handle pointing right
(D) Red handle pointing up
(E) Green handle pointing up
3. Connect other end of the hose to the pressurized fresh water source.
4. Turn ON the pressurized water source.
5. Water should now be available to all fixtures.
NOTE: To disconnect: Turn off water at the pressurized source first, disconnect
hose from the water source, (to release pressure off the system) then disconnect the
hose at the City Water Connection on Utility Center last.
“WINTERIZE” (plumbing lines and fixtures via pump)
(Refer to the Winterizing Plumbing System section before starting the winterizing process).
1. Connect a garden hose to the City Water inlet (do not use your fresh water hose to
winterize the water lines)
2. Set the colored valves to the WINTERIZE setting:
(A) White handle pointing down
(B) Blue handle pointing left
8-8
To Next Page
Loading...
Need help?
General
