SECTION 8-PLUMBING SYSTEMS JAYCO TOWABLE
To Replace Filter Cartridge
1. Turn off water supply.
2. Place drip pan below filter housing to catch any spillage.
3. Press the red button on top of the filter housing to release pressure.
4. Using a spanner wrench, rotate the filter housing. Unscrew the housing completely
and remove the filter (dispose of the old filter properly.
5. Clean the inside of the filter housing with mild detergent. Thoroughly rinse and wipe
clean.
6. Remove the o-ring from the groove in the housing and wipe clean. Recoat with
petroleum jelly.
7. Replace the o-ring in the groove, making sure it is properly seated.
8. Install the new filter cartridge.
9. Replace the canister housing (hand tighten is normally sufficient).
10. Turn on the water supply and check for leaks.
NOTE: There is no bypass feature on a canister style water filter. The water filter
must be removed before sanitizing or winterizing the RV.
Each new RV is winterized with RV antifreeze before it is shipped to the dealer. To use the
water purification system: full system canister water lines need to be flushed of antifreeze
and then the filter installed in the canister before use.
Refer to the manufacturer’s owner’s manual and the label on the water filter cartridge for
further information.
Do not allow the filter housing to freeze.
Remove the cartridge before using anti-freeze to winterize the system or chlorine
solution to sanitize the system.
Flush housing thoroughly before it is put back into service after winterizing or
sanitizing.
For best results replace cartridge every 6-12 months.
Do not use carbon cartridges where water is microbiologically unsafe or of
unknown quality.
Maximum operating pressure is 125 psi (8.75 bar).
Maximum water temperature is 125° F (52° C).
8-5
To Next Page
Loading...
Need help?
General
