LinX Series Linear Motor - User Guide
2 D-000168 Rev 02 ANCA Motion
Clean or inspect the equipment only after isolating all power sources.
Only suitably qualified personnel should install, operate, repair and/or replace this equipment.
Ensure all external wiring is clearly labelled. This will assist you and your colleagues in identifying
possible electrical safety hazards.
Use cables with the minimum cross sectional area as specified in 6.3.1 Motor Power and Temperature
Feedback.
Install cables according to local legislation and regulations as applicable.
Ensure the forcer will not move relative to the shaft while in contact with the motor electrical
connections. Movement can induce a voltage that could cause an electrical shock.
To Next Page
Loading...
