JBL TUNE600BTNC - Safety; General Safety

Safety
ANCA Motion D-000168 Rev 02 1
1
Safety 1
WARNING: Cylindrical motor shafts contain powerful permanent magnets. People with pacemakers, AICD
or similar medical devices should maintain a minimum distance of 50cm from the shaft.
DANGER HIGH VOLTAGE: Ensure power has been completely disconnected before touching electrical
connections. Electrical shock can cause serious or fatal injury.
DANGER HIGH VOLTAGE: The system must be properly earthed before applying power. Ensure the
system has been earthed according to 6.3 Electrical. National and local electrical codes must be followed.
Electrical shock can cause serious or fatal injury.
WARNING: The motor shaft emits a very strong magnetic field. To avoid injury keep fingers and other body
parts clear and do not have any ferrous or magnetised material on your person (eg. watches, keys and
electronic devices) that could be attracted to the shaft.
This manual and the warnings attached to the LinX cylindrical linear motor only highlight hazards that can be
predicted by ANCA Motion. Be aware they do not cover all possible hazards.
ANCA Motion shall not be responsible for any accidents caused by the misuse or abuse of the device by the
operator.
Safe operation of these devices is your own responsibility. By taking note of the safety precautions, tips and
warnings in this manual you can help to ensure your own safety and the safety of those around you.
General Safety 1.1
The following points must be understood and adhered to at all times:
 Equipment operators must read the User Guide carefully and make sure of the correct procedure
before operating the LinX linear motor.
 Memorize the locations of the power and drive isolator switches so that you can activate them
immediately at any time if required.
 If two or more persons are working together, establish signals so that they can communicate to
confirm safety before proceeding to another step.
 Be aware of the closest First Aid station.
 Always make sure there are no obstacles or people near the devices during installation and or
operation. Be aware of your environment and what is around you.
 Keep the vicinity of the LinX linear motor clean and tidy.
 Take precautions to ensure that your clothing, hair or personal effects (such as jewellery) cannot
become entangled in the equipment.
 Do not turn on any of the equipment without all safety features in place and known to be functioning
correctly. Never remove any covers or guards unless instructed by the procedures described in this
manual.
 The magnetic and non-load bearing nature of the shaft means that operator interaction around the
shaft must be carefully considered. Ensure appropriate warnings and/or guards are installed to prevent
damage to the machine or operator.
 Never touch any exposed wiring, connections or fittings while the equipment is in operation.
 Visually check all switches on the operator panel before operating them.
 Do not apply any mechanical force to the LinX linear motor which may cause malfunction or failure.
 Never attempt cleaning or inspection during machine operation.