2-3
!!
CAUTION
Always face the machine when entering (and leaving) the
cab. Make sure your shoes and hands are clean and dry.
Otherwise you could slip and fall.
2-2-1-3
Entering the Cab
1 Open the cab door and, if necessary, secure it in the
fully open position (see Doors and Windows, Opening
and Closing the Door).
2 Check that the Controls Lock Lever (see Switches
and Controls) is raised.
3 Holding the two handrails (one each side of the cab
entrance), climb onto the top of the track (as at A). Do
not use the skirt 1 as a step.
4 Retaining hold of the left handrail, step into the cab and
swing yourself into the operator’s seat (as at B).
!!
WARNING
Do not use the machine controls as handholds when
entering (or leaving) the machine.
2-2-1-4
Leaving the Cab
1 Stop the engine and, with the Starter Switch set to ON,
operate the hydraulic controls several times to release
any residual hydraulic pressure in the system. Turn the
Starter Switch OFF.
2 Open the cab door and, if necessary, secure it in the
fully open position (see Doors and Windows, Opening
and Closing the Door).
3 Press the Servo Isolator Switch (see Facia Panel)to
isolate the controls.
4 Raise the Controls Lock Lever (see Switches and
Controls).
5 Leave the cab by reversing instructions 3 and 4 of
Entering the Cab. Do not use the skirt 1 as a step.
Section 1 General Information
9803/9330
Section 1
2-3
Issue 1
Operation
AA
BB
11
11
To Next Page
Loading...
