4-1
Switches and Controls
Right Console
1 Starter Switch
This is operated by the starter key. It has four positions.
The key can only be removed when in the 'O' position.
O Off/Stop Engine
Turn the key to this position to stop the engine. Make
sure the controls are in neutral and the excavator and
dozer are lowered before stopping the engine.
I On
Turning the key in this position connects the battery to
the electrical circuits The key will spring back to this
position when released from ll.
II Heat Position (Not Functional)
Turning the switch to this position has no effect. The
engine is pre-heated automatically if necessary.
lll Start
Operates the starter motor to turn the engine.
Note: Do not operate the starter for more than 20
seconds at one time. If the engine does not start in this
time, return the key to the ‘O’ position. Wait at least one
minute before trying again. The switch mechanism
prevents you from reselecting ‘Start’ without first
returning to ‘O’.
2 Throttle Dial
This rotary control provides progressive engine speed
control over the full range.
Note: If the engine speed does not change even after
turning the throttle dial it may be because the idle switch
6 is ON. Push the idle switch to OFF to reactivate the
throttle dial.
If the engine is started with the throttle dial not at the
minimum position, no engine speed control will be
possible until the dial is turned to the minimum position.
Section 1 General Information
9803/9330
Section 1
4-1
Issue 1
Operation
11
22
33
44
77
55
66
11
To Next Page
Loading...
