Underseat Tool Box and Cool Box
For operator convenience a toolbox A and coolbox B are
located under the seat.
The coolbox includes a vent C which allows you to control
the level of coolness in the coolbox.
4-2
Switches and Controls (cont’d)
Right Console (cont'd)
3 Radio Mute Switch
This switch is used to temporarily switch the sound
from the radio OFF. When the mute switch is selected
the indicator light will illuminate. When the switch is
reselected the radio sound will resume and the indicator
will extinguish.
4, 5 High-Flow Auxiliary Switches
These switches operate high-flow hydraulic
attachments, such as augers. Press and hold switch 4
to operate the attachment in the ‘forward’ direction.
Press and hold switch 5 to operate the attachment in
the ‘reverse’ direction.
Note: ‘Forward’ and ‘reverse’ directions will be determined
by the hydraulic connections to the attachment.
Forward operation can also be activated by a foot-
operated switch, see Operating Attachments.
Note that the EMS will prevent the high flow circuit
operating if the hydraulic oil temperature is at or below
0 °C (32 °F), or if is at or higher than 98 °C (208 °F).
6 One Touch Idle Switch
Pressing this switch instantly changes the engine speed
back and forth between that selected for working and a
‘low idling’ speed. When ‘low idling’ has been selected
the message “LOW IDLE” is displayed on the EMS
Panel.
7 Cigar Lighter/12 V Power Point
To operate the lighter, press it fully into its socket. When
it has heated up sufficiently it will spring forward a little
way out of its socket. It can then be removed for use.
REMEMBER IT WILL BE HOT. Return the lighter to its
socket after use.
This machine is equipped with a 12 V system and can
be used for mobile phone chargers or other 12 V
powered devices (maximum current 5 A).
Section 1 General Information
9803/9330
Section 1
4-2
Issue 1
Operation
To Next Page
Loading...
