i
Section 1 General Information
9803/9330
Section 1
i
Issue 1
Contents Page No.
Identifying your Machine
Identification Plates 1 - 1
Operation
Introduction 2 - 1
Before Entering the Cab 2 - 2
Entering/Leaving the Cab 2 - 3
Opening and Closing the Door 2 - 4
Opening and Closing the Front Upper Window 2 - 4
Opening and Closing the Front Lower Window 2 - 5
Emergency Exit 2 - 5
Door Sliding Window 2 - 5
Opening and Closing the Sunblind 2 - 5
Seat 2 - 6
Seat Belt 2 - 6
Location of Controls and Components 3 - 1
Switches and Controls 4 - 1
Right Console 4 - 1
Underseat Tool Box and Cool Box 4 - 2
Heater/Air Conditioning Controls 4 - 3
Left Console 4 - 4
EMS Panel 4 - 5
Facia Panel 4 - 9
Redundancy Switch 4 - 10
Mechanical Engine Speed Override 4 - 10
Servo Controls Immobilisation 4 - 10
Cab Interior Light 4 - 11
Radio (Optional) 4 - 11
Travel Levers 4 - 12
Travel Speed Change Button 4 - 12
Excavating Controls 5 - 1
Operation 5 - 1
Slewing 5 - 2
Boom Swing 5 - 3
Boom Swing Stop 5 - 3
Boom Raise/Lower 5 - 4
Dipper In/Out 5 - 5
Bucket Close/Open 5 - 6
Refuelling 6 - 1
Fuel Level 6 - 1
Filling the Tank 6 - 1
Refuelling Pump (optional) 6 - 2
Before Starting the Engine 6 - 3
Starting the Engine 6 - 4
Jump-Starting the Engine 6 - 5
Warming Up 6 - 6
Operating in Cold Climates 6 - 7
Operating in High Temperatures 6 - 7
Operating in Dusty or Sandy Areas 6 - 7
Operating in Coastal Regions 6 - 7
Operating on Wet or Soft Ground 6 - 7
Preparing for Travel 6 - 8
Stopping and Parking the Machine 6 - 9
Working on Slopes 7 - 1
Digging Near Walls 7 - 1
Dumping into a Truck 7 - 1
To Next Page
Loading...
