4-9
Switches and Controls (cont’d)
Facia Panel
1 Emergency Stop
Press to stop the engine. The EMS Panel will display
“EMER STOP”. Press again to allow the engine to be re-
started.
2 Slew Lock
Press to enable the slew lock The monitor will display
“SLEW LOCK”. This message will flash until the Slew
Lock engages, at which point the message will stop
flashing. Press again to release the slew lock. (The EMS
will prevent the Slew Lock from engaging until the
machine has stopped slewing and the slew brake has
engaged.)
3 Overload Caution (Option)
Use this to switch the Overload Caution system on and
off. When the system is ON, if a load exceeding the lift
capacity of the machine is lifted the monitor will display
“OVERLOAD” warning message and a buzzer will
sound. (This feature is only available when Hose Burst
Check Valves are installed.)
4 Work Lights
Press once to switch on the boom and front worklights.
Press a second time to switch on the rear worklight (the
boom and front worklights will remain lit).
Press a third time to switch all these lights off.
5 Servo Isolator
Press to isolate the servo system. The monitor will
display “ISOLATOR”. When pressed the controls are
isolated and no machine movement is possible. Press
again to de-isolate the system.
6 Quickhitch (option) - Position bucket on floor
When a quickhitch system is fitted, press to release the
hitch. The monitor will display “Q/H DISCON?” and the
alarm will sound, press ACK switch on the monitor
within 5 seconds. The monitor will display “Q/H
DISCON”. Press again to re-apply the quickhitch.
7 Beacon (option)
When a beacon is fitted, press to activate the beacon.
The monitor will display “BEACON ON”. The switch
gives power to the jack socket into which the rotating
beacon or the service inspection lamp is plugged.
8 Windscreen Washer
Press to operate the windscreen washer. The washer will
stop when the button is released. The windscreen wiper
will operate for approximately four wipes once the
button is released. The button’s LED will flash during
intermittent operation and remain lit during continuous
operation.
9 Wiper
Press once to operate the wiper in intermittent mode. The
monitor will display “WIPER INT”. The frequency of wipe
can be adjusted using the EMS menu. Press a second time
to operate the wiper continuously. The monitor will display
“WIPER ON”.
10 Auto Idle
Press the switch to activate the automatic engine idle
system. The monitor will display “AUTO IDLE”. The
engine speed will drop to idle when the machine
hydraulics have remained unused for 5 seconds; the
monitor will display “LOW IDLE”. The time delay can be
adjusted by the monitor menu. (See EMS Panel, Set
Mode.)
Note: Regardless of the state of this switch, you can
manually switch to and from LOW IDLE using the One
Touch Idle Switch, see Right Console.
Section 1 General Information
9803/9330
Section 1
4-9
Issue 1
Operation
11
22
33
44
55 66
77
88
99
00
To Next Page
Loading...
