4-8
Switches and Controls (cont’d)
EMS Panel (cont’d)
Diagnostic Mode
The EMS Diagnostic Mode allows the operator or service personnel to display various parameters monitored by the EMS.
Pressing the SET button and the MODE button together for 5 seconds enters the Diagnostic Mode menu. The message
“MODEL TYPE” will indicate that the EMS is in Diagnostic Mode. Pressing the Scroll Up and Scroll Down buttons will cycle
through the entries, and pressing the ACK button will select an item. Pressing the SET button will return the operator to the
normal display.
The Diagnostic Mode messages are listed below.
Diagnostic Mode Messages
Section 1 General Information
9803/9330
Section 1
4-8
Issue 1
Operation
Message Display Meaning
ALT CHARGE Shows if the alternator is charging or not.
ECU--M--v X.XX The hardware or software version number for the ECU-MIDI.
EMS--v X.XX The hardware or software version number for the EMS.
FUEL LEVEL Display the amount of fuel remaining.
HRDWARE VER Display the hardware version numbers of the EMS and the ECU-MIDI.
HYD TEMP Display the current hydraulic oil temperature.
MAIN OFF Main pressure switch is off.
MAIN ON Main pressure switch is on.
MODEL NUM Show the model of the vehicle.
OFF The alternator is not charging.
ON The alternator is charging.
PILOT SWITCH Show the state of the machine pressure switches.
QH ENABLE? Menu option for enabling and configuring the Quickhitch.
QH OFF Disable the Quickhitch.
QH ON Enable the Quickhitch.
QH TYPE 1 Set the Quickhitch to type 1.
QH TYPE 2 Set the Quickhitch to type 2.
QH TYPE ? Set the type of Quickhitch on the machine.
SENSE POT Displays the reading of the throttle sense potentiometer.
SENSOR VOLT Displays the measurement of the sensor voltage (5V supply).
SERIAL NO Display the serial number of the machine.
SFTWARE VER Display the software version numbers of the EMS and the ECU-MIDI.
SWING OFF Swing pressure switch is off.
SWING ON Swing pressure switch is on.
SYS VOLTS Displays the measurement of the battery voltage.
THROTTL PWM Displays the PWM duty cycle being provided to the throttle actuator.
THRTTLE POT Displays the reading of the throttle set potentiometer.
TRAVEL OFF Travel pressure switch is off.
TRAVEL ON Travel pressure switch is on.
WATER TEMP Displays the current engine water temperature.
X.XX VOLTS The sensor voltage reading.
XX DEG C Current temperature reading of either the water or hydraulic fuel.
XX PERC The reading of the fuel level given in percent full.
XX VOLTS The battery voltage reading.
XX.X PERC The PWM reading in percent duty cycle.
XXXX OHMS The measurement in Ohms of the throttle sensor set potentiometer.
To Next Page
Loading...
