To Next PageTo Next Page
Need help?Do you have a question about the jcb 8080 and is the answer not in the manual?
General| Brand | jcb |
|---|---|
| Model | 8080 |
| Category | Excavators |
| Language | English |
Explains the numbered and alphabetically coded sections of the manual for clarity.
Describes the standardized colour coding for oil pressure and flow in illustrations.
Details the location of the machine's VIN number on the data plate.
Explains the location of the engine serial number and replacement procedures.
Guides the operator through learning the machine's controls and safe operation.
Details essential checks for cleanliness, damage, and security before operating.
Step-by-step guide on how to safely enter the machine's cab.
Step-by-step guide on how to safely exit the machine's cab.
Instructions for opening and securely closing the machine's cab door.
Details on how to operate the front upper cab window safely.
Instructions for opening and closing the front lower cab window.
Steps for using the rear window as an emergency exit.
How to operate and position the cab sunblind.
Guide to adjusting the operator's seat for comfort and control reach.
Instructions for fastening, releasing, and adjusting the seat belt for safety.
Identifies controls located on the right side of the operator's console.
Identifies controls located on the left side of the operator's console.
Locates essential pedals and levers for machine operation.
Explains the function and operation of the engine's starter switch.
Details how to use the rotary control for engine speed adjustment.
Operation of switches for high-flow hydraulic attachments.
Function of the switch to change engine speed to idle.
Usage of the 12V power outlet for accessories.
How to use the air conditioning system for different weather conditions.
Operation of the heater fan speed and temperature adjustment.
How to use the horn for signaling.
Explains the function of the lever for isolating hydraulic controls.
Description of the LCD display, bar graphs, and message area.
How to select working modes (Standard, Heavy, Light).
Usage of Set and ACK buttons for menu navigation and acknowledgments.
Explains icons displayed on the EMS panel for time and hours.
Details the meaning of various warning and status lamps on the EMS panel.
Describes Set, Diagnostic, and Calibration modes for the EMS panel.
Lists repetitive warning messages and their meanings.
How to enter the diagnostic mode for parameter display.
A comprehensive list of diagnostic messages and their meanings.
Operation of the emergency stop and slew lock switches.
Controls for work lights and isolating machine servo systems.
How to operate optional quickhitch and beacon features.
Operation of the windscreen wiper and auto idle system.
How to operate the machine in redundancy (LIMP) mode.
Adjustment of engine speed using the override screw.
Methods to immobilise machine servo controls for safety.
How to operate the interior light and its door-activated function.
Details on controls and features of the optional radio system.
How to use the levers and pedals for controlling machine travel.
How to select between high and low travel speed modes.
Introduction to controlling excavation using joysticks and other controls.
Important safety advice for excavation work to prevent damage.
Warnings and precautions for safe slewing operations.
How to control the slewing movement of the superstructure.
How to operate the boom swing left and right using pedals.
Description of the optional boom swing stop for wide buckets.
How to raise the boom using the controller.
How to lower the boom using the controller.
