EasyManuals Logo

jcb JS70 Service Manual

jcb JS70
385 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #143 background imageLoading...
Page #143 background image
4 - 10
Boom Ram (continued)
Boom Down
5 Prepare the machine
Put the operator levers into neutral and lower the gate
lock lever. Start the engine and park the machine on
level ground. Operate the dipper out and lower the
boom to set the bucket on the ground. Lower the blade
onto the ground. Stop the engine. Release the hydraulic
oil tank pressure. (See Releasing Tank Pressure).
6 It is not physically possible to fully close the boom ram,
without lifting the undercarriage of the ground.
Therefore the ARV’s B and C must be swapped over.
a Fully raise the boom and then continue to operate
the right control lever as at A.
b The pressure gauge reading (Boom down) should be
compared to the technical data at the start of the
section. If it is outside the limits, adjust ARV.
7 Stop the engine and release the hydraulic pressure,
(see Releasing Tank Pressure). Remove the pressure
gauge and adaptor. The Relief Valves for Boom up and
Boom down must be swapped and returned to the
correct ports.
8 If further ARV tests are necessary carry out the relevant
procedures detailed in this section. If no further ARV
tests are required restore the MRV pressure setting to
its original value (see Auxiliary Relief Valve, General,
step 3).
9 Stop the engine and release the hydraulic pressure,
(see Releasing Tank Pressure). Remove the pressure
gauge and adaptor.
Section E Hydraulics
9803/6020
Section E
4 - 10
Issue 1
Pressure Testing
12
SLMODE
AA
282490
284430
289910
289530
XX
CC
BB
YY

Table of Contents

Other manuals for jcb JS70

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the jcb JS70 and is the answer not in the manual?

jcb JS70 Specifications

General IconGeneral
Brandjcb
ModelJS70
CategoryExcavators
LanguageEnglish

Related product manuals