Offset Boom Ram - Replacement (cont’d)
1 Use a suitable hoist and sling (the ram weighs 42 kg (92
lb)), to align the offset ram cylinder ram eye with the
main boom pivot point.
2 Install the pivot pin and secure with the bolt and nuts.
!!
WARNING
Metal Splinters
You can be injured by flying metal splinters when driving
metal pins in or out. Use a soft faced hammer or drift to
remove and fit metal pins. Always wear safety glasses.
INT-3-1-3
3 Connect the hoses to the offset ram.
4 Align the piston rod eye with the offset boom pivot
point.
75 - 3
Section E Hydraulics
9803/6020
Section E
75 - 3
Issue 1
Hydraulic Rams
284820
284830
284840
284850
To Next Page
Loading...
