Blade Ram - Removal (cont’d)
4 Use a wire to hold the piston rod inside the cylinder.
5 Disconnect the blade ram hoses. Install plugs or caps
to prevent contamination.
6 Using a hoist capable of supporting the ram weight of
42 kg (92 lb), attach a sling to the ram.
7. Remove the nuts and bolt securing the blade pivot pin.
Knock out the pivot pin.
!!
WARNING
Metal Splinters
You can be injured by flying metal splinters when driving
metal pins in or out. Use a soft faced hammer or drift to
remove and fit metal pins. Always wear safety glasses.
INT-3-1-3
76 - 2
Section E Hydraulics
9803/6020
Section E
76 - 2
Issue 1
Hydraulic Rams
284900
284910
284920
284930
To Next Page
Loading...
