8 - 2
Section 3 Routine Maintenance
9803/6020
Section 3
8 - 2
Issue 1
Engine (continued)
Changing the Inner Element
1 Locate the Air Filter
See Component Location Diagrams at the end of
this section.
2 Stop the Engine
Remove the starter key.
3 Open the Hydraulic Compartment
4 Disconnect the Filter Induction Hose
To prevent dust getting into the engine, disconnect the
induction hose A. Cover the hose to prevent rain and
dirt getting into the engine.
5 Remove the End Cover
Unscrew knob G. Pull off the end cover H.
6 Remove the Outer Element
Unscrew nut E. Pull out the outer element J.
7 Remove the Inner Element
Unscrew nut K. Pull out the inner element L.
8 Clean the Canister
Clean the inside of the canister D, the end cover H
and dust valve F.
9 Fit the New Inner Element
Carefully insert the new inner element into the
canister. Make sure it seats correctly, by smearing the
seal B with grease and checking for a witness mark
on the canister base. Fit and tighten nut K.
10 Fit the Outer Element
Carefully insert the new outer element into the
canister. Make sure it seats correctly, by smearing the
seal C with grease and checking for a witness mark
on the canister base. Fit and tighten nut E.
11 Fit the End Cover
Fit the end cover H onto the canister. Make sure the
dust valve F is at the bottom. Tighten knob G.
12 Connect the Induction Hose
Connect the induction hose. Make sure the air filter
blocked switch connector is fitted.
Check all hoses for condition and tightness.
F
D
E
K
L
H
A
B
C
J
G
To Next Page
Loading...
