DO NOT Grab The Door Handle When Locking
NOTE:
● After pushing the Passive Entry button on the door
handle to lock the doors, the v
ehicle will not allow
you to unlock the vehicle by the door handle for
approximately two seconds. This is done to allow you
to check if the vehicle is locked by pulling the door
handle without the vehicle unlocking.
● If Passive Entry is disabled using the Uconnect
Settings, the key protection described in "Frequency
Operated Button Integrated Key (FOBIK-Safe)"
remains active/functional.
● The Passive Entry system will not operate if the key
fob battery is depleted.
To Unlock/Enter The Liftgate
The lif
tgate Passive Entry unlock feature is built into the
electronic liftgat
e release handle. With a valid Passive
Entry key fob within 5 ft (1.5 m) of the liftgate, push the
electronic liftgate release handle to open.
NOTE:
● If the vehicle is unlocked, the liftgate will open with
the handle and no key fob is required.
● The liftgate will either unlock along with the vehicle
doors, or it will need to be unlocked by pushing the
electronic liftgate release, depending on the selected
setting in the Uconnect system
ð
page 153.
● The liftgate (and vehicle doors if unlocked) must be
locked using the lock button on the key fob, the
Passive Entry lock button, or the lock buttons on the
interior front door panels.
Electronic Liftgate Release/
Liftgate Passive Entry Location
AUTOMATIC U
NLOCK DOORS ON EXIT
The doors will unlock automatically on vehicles with
power door locks if:
1. The Automatic Unlock Doors On Exit feature is
enabled within Uconnect Settings
ð
page 153.
2. All doors are closed.
3. For vehicles equipped with automatic
transmissions, the transmission gear selector was
not in PARK, then is placed in PARK. For vehicles
equipped with manual transmissions, the vehicle
must not be moving and the clutch is released.
28 GETTING T
O KNOW YOUR VEHICLE
To Next Page
Loading...
