Back Up Camera View
Pressing the Back Up Camera button will
provide a full screen rear view with Zoom
View.
NOTE:
If the Rear View Camera view was selected through the
Surround View Camera menu, exiting out of the Rear
View screen will return to the Surround View menu. If
the Back Up Camera was manually activated through
the Controls menu of the Uconnect system, exiting out
of the display screen will return to the Controls menu.
Deactivation
The system can be deactivated under the following
conditions:
● The speed of the vehicle is greater than 8 mph (13
km/h).
● The vehicle is shifted into PARK.
● The vehicle is in any gear other than REVERSE and
the touchscreen X button is pressed.
● The camera delay system is turned off manually
through the Uconnect Settings menu
ð
page 153.
NOTE:
● If snow, ice, mud, or any foreign substance builds up
on the camera lenses, clean the lenses, rinse with
water, and dry with a soft cloth. Do not cover the
lenses.
● If a malfunction with the system has occurred, see
an authorized dealer.
WARNING!
Drivers must be careful when backing up even
when using the Surround View Camera. Always check
carefully behind your vehicle, and be sure to check
for pedestrians, animals, other vehicles, obstructions,
or blind spo
ts before backing up. You are responsible
for the safety of your surroundings and must continue
to pay attention while backing up. Failure to do so can
result in serious injury or death.
CAUTION!
● To avoid vehicle damage, Surround View should
only be used as a parking aid. The Surround View
camera is unable to view every obstacle or object
in your driv
e path.
(Continued)
CAUTION!
● T
o avoid vehicle damage, the vehicle must be
driven slowly when using Surround View to be able
to stop in time when an obstacle is seen. It is
recommended that the driver look frequently o
ver
his/her shoulder when using Surround View.
ZOOM VIEW
When the Rear View Camera image is being displayed,
and the vehicle speed is below 8 mph (13 km/h) while
in any gear selector position, Zoom View is available.
By pressing the “magnifying glass” icon
in the upper left of the display screen,
the image will zoom in to four times the
standard view.
Pressing the icon a second time will return
the view to the standard Back Up Camera
display.
When the Back Up Camera View is activated, the
default view is the standard Back Up Camera view,
while in any gear. When Zoom View is selected
while the vehicle is in REVERSE, then shifted to
DRIVE or NEUTRAL, the camera will display the
standard Back Up Camera view. If the vehicle is then
STARTING AND OPERATING 143
To Next Page
Loading...
