INSTRUMENT CLUSTER DESCRIPTIONS
1. Tachome
ter
● Indicates the engine speed in revolutions per
minute (RPM x 1000).
2. Instrument Cluster Display
● The instrument cluster display features a driver
interactive display
ð
page 84.
3. Speedometer
● Indicates vehicle speed.
4. Temperature Gauge
● The temperature gauge shows engine coolant
temperature. Any reading within the normal
range indicates that the engine cooling system
is operating satisfactorily.
● The gauge point
er will likely indicate a higher
temperature when driving in hot weather or up
mountain grades. It should not be allowed to
exceed the upper limits of the normal operating
range.
WARNING!
A hot engine cooling system is dangerous. You
or others could be badly burned by steam or
boiling coolant. It is recommended to call an
authorized dealer for service if your vehicle
o
verheats.
CAUTION!
Driving with a hot engine cooling system
could damage your vehicle. If the temperature
gauge reads “H” pull over and stop the
vehicle. Idle the vehicle with the air
(Continued)
CAUTION!
conditioner turned off until the pointer drops
back into the normal range. If the pointer
remains on the “H”, turn the engine off
immediately and call an authorized dealer for
service.
5. Fuel Gauge
● The gauge shows the level of fuel in the fuel
tank when the ignition switch is in the ON/RUN
position.
● The fuel pump symbol points to the
side of the vehicle where the fuel
door is located.
NOTE:
The hard telltales will illuminate for a bulb check when
the ignition is first cycled.
76 GETTING TO KNOW YOUR INSTRUMENT PANEL
To Next Page
Loading...
