Activate The Active Speed Limiter (When Speed Setting
Is Memorized)
When the RES (resume) button on the steering wheel
is pushed, the speed limit will be set to the memorized
speed.
NOTE:
If the memorized speed limit is lower than the current
vehicle speed, the Active Speed Limiter will not operate
even though you try to set. In this case, a corresponding
message will be displayed in the instrument panel.
Display During Activation
When the Active Speed Limiter is active, the set speed
limit will be displayed in the instrument panel, and the
Active Speed Limiter indicator light will turn to green.
To Temporarily Deactivate The Active Speed Limiter
The Active Speed Limiter may be temporarily
deactivated when the accelerator pedal is fully pressed
while driving with the Active Speed Limiter activated. In
this case, the corresponding message will be displayed
in the instrument panel.
To Change The Speed Limit
Press the SET+ or SET- button on the steering wheel
while the Active Speed Limiter is active. If the SET+ or
SET- button is pressed and held down, the speed limit
will change in the increments by 5 mph (5 km/h).
Return The Active Speed Limiter To Standby
If you press the CANC button on the steering wheel
while the Active Speed Limiter is active, the Active
Speed Limiter will be deactivated and return to standby.
The speed limit display on the instrument panel will turn
off but the set speed will still be memorized.
To Deactivate The Active Speed Limiter
If you press the setting button while the Active Speed
Limiter is at standby, the Active Speed Limiter will be
deactivated. The indicator light in the instrument panel
will turn off and the memorized speed will be erased.
NOTE:
The Cruise Control (if equipped) system will be
unavailable while the Active Speed Limiter is in use.
If the Cruise Control system is set, the Active Speed
Limiter will be canceled.
EXCEEDING THE SET SPEED
By fully pressing the accelerator pedal, the programmed
maximum speed can be exceeded while the device is
active.
In the event that the Active Speed Limiter set value
is exceeded manually with a driver acceleration, the
indicator light will flash, and a message will appear in
the instrument cluster display.
The feature will remain disabled until the vehicle speed
drops below the set Active Speed Limiter value, when it
will reactivate automatically.
DEACTIVATION
To turn off Active Speed Limiter, push the Active Speed
Limiter button on the right side of the steering wheel. A
message will appear in the instrument cluster display to
confirm that the feature has been turned off. You can
also deactivate Active Speed Limiter by pressing the
CANC button. In this case, the system is not completely
turned off, and the driver can reactivate the Active
Speed Limiter by pressing the RES button.
CRUISE CONTROL SYSTEMS — IF
EQUIPPED
CRUISE CONTROL
When engaged, the Cruise Control takes over
accelerator operations at speeds greater than 25 mph
(40 km/h).
STARTING AND OPERATING 133
To Next Page
Loading...
