Diesel Emissions Additive AdBlue® (UREA) Fault Warning Messages:
MESSAGE DESCRIPTION
Engine Will Not Restart Service AdBlue®
System See Dealer
This message will display if AdBlue® (UREA) system issue detected is not serviced during the allowed period. Your engine will not
restart unless your vehicle is serviced by an authorized dealer. If the level is not resolved, an additional warning appear whenever a
certain threshold is reached until it will no longer be possible to start the engine. When 125 miles (200 km) are remaining before
the AdBlue® tank is empty, a message will appear on the instrument panel, accompanied by a buzzer sound.
Engine Will Not Start Service AdBlue®
System See Dealer
NOTE:
● The display may take up to five seconds to update after adding two gallons (7.5 Liters) or more of AdBlue® (UREA) to the
AdBlue® (UREA) tank. If you have a fault related to the AdBlue® (UREA) system, the display may not update to the new level. See
an authorized dealer for service.
● AdBlue® freezes at temperatures lower than 12°F (-11°C). If the car stands for a long time at this temperature, refilling could
be difficult. For this reason, it is advised to park the vehicle in a garage and/or heated environment, and wait for the AdBlue®
(UREA) to return to liquid state before topping up.
BA
TTERY SAVER O
N
/BA
TTER
Y
S
A
VER M
ODE
MESSAGE — ELECTRICAL LOAD REDUCTION
ACTIONS — IF EQUIPPED
This vehicle is equipped with an Intelligent Battery
Sensor (IBS) to perform additional monitoring of the
electrical system and status of the vehicle battery.
In cases when the IBS detects charging system failure,
or the vehicle battery conditions are deteriorating,
electrical load reduction actions will take place to
ext
end the driving time and distance of the vehicle.
This is done by reducing power to or turning off non-
essential electrical loads.
Load reduction is only active when the engine is
running. It will display a message if there is a risk of
battery depletion to the point where the vehicle may
stall due to lack of electrical supply, or will not restart
after the current drive cycle.
When load reduction is activated, the message “Battery
Saver On” or “Battery Saver Mode” will appear in the
instrument cluster display.
These messages indicate the vehicle battery has a low
state of charge and continues to lose electrical charge
at a rate that the charging system cannot sustain.
GETTING TO KNOW YOUR INSTRUMENT PANEL 97
To Next Page
Loading...
