Jensen A1000 User Manual

A1000 Amplifier
Wiring Instructions
This section explains how to wire the A I (X){) power amplifier to your vehicle system.
Important:
If wiring connections are made wrong, the unit will not operate properly and it could be damaged. Follow
the installation instructions carefully or have the installation handled by an experienced technician.
wh1te
red
ql
Radio
Signal Ground
red
-OR-
Splice (as ""'-
necessary) W~IWIWII
Use 00y IWh high level inputs.
Connect 10 a labelled "ground"
tenninal or a clean, tnpainted metal
part of the racflO dlassis.
Inputs may be high level Urom the receive,s
speaker) or k:m level (Irom special k:m level outputs).
Low level input is preferred for best performance.
Imporlan1:
Use either /owlevel or
high level inputs. Never
comect both high and
low level Inputs.
The A 1 000 has two inputs an:! corresponding
speaker output circuits,labeIIed l and R Inputs
an:! speaker outputs can be left and right or any
other conflQUfation of channels desired.
SPEAKER OUTPUT: CAUTION!
00 NOTCOt.NECT l-ANO f!-..
HI lEVCl INPUT TOGETHER OR TOGROUND.
Ilg-ggll @~@
I I I I
L. l- R_ R.
J
---C
left .. • Righi
Speaker .. .... .•.. Speaker
®
(+) • (+)®
~ ........ ~
H (-)
In-line
Fuse
Con_lo the vehicle battery. Use 12 AWG \We orlarger. + 12V
This coonection must be made last (yelow)
The amplifier will not work if this wire is not connected. Connect Sensing _-==,{J
10 the pctM9r antema klads of the ra<io, K one is avaiWe. H one is (bUiI
rot avaiable, oonned to a + 12V source that is rlYB Vwilen igliOOn is 00 ....rite)
an:! k1activev.l1oo 'Titian is off. Use 18AWGvkeorlarger ..
Connect 10 either a t:IbeDed "gomd' tenninal or to a clean, Ground "):)1::3==1)
u,-"ailled !Mlal part of the chassis. Use 12 AWG \We or larger. (b'ad<)' 0
6

Jensen A1000 Specifications

General

Brand	Jensen
Model	A1000
Category	Amplifier
Language	English