EasyManuals Logo
Home>Jensen>Car Stereo System>AWM970

Jensen AWM970 User Manual

Jensen AWM970
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
AWM970
6
Basic Operation (continued)
Clock Setup
Press and hold the T/F button (8) to access Clock Setup mode. The number representing the
hours will flash. Rotate the TUN/TRK control (12) to adjust the hour. Press T/F again briefly
and the number representing the minutes will flash. Rotate the TUN/TRK control to adjust the
minutes. The new time will be saved five seconds after the last adjustment is made.
Setting the Sleep Time
The Sleep Timer will automatically turn off the AWM970 in the designated number of minutes.
To set the Sleep Time, press the ALARM SET button (9a) and the sleep time will appear in the
display with the number representing the minutes (SLEEP 0). Press ALARM SET repeatedly
to change the sleep time from 15 to 30, 45 or 60 minutes.
Setting the Alarm
To set the alarm, press and hold the ALARM SET button (9a). The number representing the
hours will flash. Rotate the TUN/TRK control (12) to adjust the hour. Press ALARM SET again
briefly and the number representing the minutes will flash. Rotate the TUN/TRK control to
adjust the minutes. Press and hold the ALARM SET button again to store the alarm time.
Once a time is set, press ALARM ON/OFF (9b) to turn the alarm function on or off.
Speaker Output
The three speaker output buttons (10) (SPEAKER A, SPEAKER B and SPEAKER C) control
speaker output from the radio. Press any of the three buttons to turn the corresponding
speaker sets on or off. The red light above each button will illuminate when that speaker set is
on.

Other manuals for Jensen AWM970

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jensen AWM970 and is the answer not in the manual?

Jensen AWM970 Specifications

Power IconPower
power supply requirementsDC 12 Volts, Negative Ground
operating voltage10-16VDC
FM Tuner IconFM Tuner
tuning range87.5-107.9FM
sensitivity<2.5uV
stereo separation at 1 kHz>30dB
AM Tuner IconAM Tuner
tuning range530-1710
sensitivity<15uV
Amplifier IconAmplifier
output power108 Watts Total (18 Watts per Channel)
output impedanceCompatible with 4-8 Ohm Speakers, 4 Ohm Load Minimum
DVD IconDVD
frequency response20-20, 000 Hz
channel separation50dB
signal-to-noise ratio70dB
distortion0.2%
Weight and Dimensions IconWeight and Dimensions
overall dimensions265mm(W)x178mm(H)x159mm(D)
mounting dimensions235mm(W)x154mm(H)x133mm(D)
weight5.5 lbs

Related product manuals