E-13
IMPORTANT: Only use the button for opening and closing the CD tray. Do not push
on the CD tray to close it after loading a CD. This could damage the internal mechanism
used for opening and closing the CD tray.
5. Press the PLAY/PAUSE
Button on main unit or remote control, PLAY indicator
shows
in display, the CD will start playing from first track.
6. Rotate the VOLUME knob on main unit or press the VOL+/- buttons on remote control to adjust
the desired volume level.
7. To pause playback, press the PLAY/PAUSE
Button on main unit or remote control. The
track time will be paused and PAUSE indicator will show in display. To resume playing, press
the CD PLAY/PAUSE
Button again.
8. You can choose to play your favorite track directly by pressing either the SKIP NEXT
Button or SKIP PREVIOUS Button. The LCD Display will indicate the correct track
number selected.
9. To locate a particular section within a track, press and hold the Button until the
section is found. Release the button to continue playing your selection.
10. To stop playing, press the STOP
Button.
11. Turn off the JBS-210 when you finish listening.
SKIP AND SEARCH MODE
1. During Play or Pause mode, tap the SKIP NEXT or SKIP PREVIOUS Button to go to
the next track or go back to the beginning of the current track.
2. During playback, press and hold the Button to search within the current track with
audible high speed playback.
DIFFERENT PLAY MODES (REMOTE CONTROL ONLY)
Press the PLAY MODE Button on remote control repeatedly to select different of play modes when
CD is playing.
When playing CD, the play modes are shown as below.
Repeat 1 ¨Repeat All ¨Random ¨Normal
REPEAT 1 - the track being played and will repeat continuously. Repeat one icon “REP” shows in
display.
REPEAT ALL - all tracks will repeat continuously. Repeat All icon “REP ALL” shows in display.
RANDOM – the tracks in the disc will be played in random sequence. Random icon “RAND” shows
in display.
PLAY TRACK SEQUENCE PROGRAMMING
This function allows the tracks to be played in a programmed sequence.
NOTE: Program can only be set in STOP mode.
1. Tap the MEMORY Button on main unit or MEM. Button on remote control, the program
number “1” shows in display, “PROG” icon and CD track number “- -“ also flashing in the LCD
display. (Note: ”1 --” will be in the display if you are programming first time).
2. Use the Button on main unit or remote contr
ol to select the desired track. The
track number will be shown in display.
3. Tap the MEMORY Button on main unit or MEM. Button on remote control to store the
selected track in the memory, the next program number will advance one (i.e.“2”) in LCD
display.
or
o r
o r
To Next Page
Loading...
