EasyManuals Logo
Home>Jensen>Car Receiver>JRV212T

Jensen JRV212T User Manual

Jensen JRV212T
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
JRV212T
22
TROUBLESHOOTING
Symptom Cause Solution
No power The vehicle’s ignition is not on If the power supply is properly connected to the vehicle
accessory terminal, switch the ignition key to “ACC”.
The fuse is blown Replace the fuse.
Disc cannot be loaded or
ejected
Presence of CD disc inside the player Remove the disc in the player and insert the new one.
Inserting the disc in reverse direction Insert the compact disc with the label facing upward.
Compact disc is extremely dirty or
disc is defective
Clean the disc or try to play a new one.
Temperature inside the vehicle is too
high
Wait until the ambient temperature returns to normal.
Condensation Leave the player off for an hour or so, then try again.
No sound Volume is too low Adjust volume to audible level.
Fader is set incorrectly Press AUDIO button to access menu and adjust Fader
settings.
Wiring is not properly connected. Check wiring connections.
Mute is on or Camera Mic is active in
camera mode
Turn Mute Off or Turn Mic Off in camera mode
The operation keys do
not work
The built-in microcomputer is not
operating properly due to noise
Press the RESET button.
Sound skips The installation angle is more than 30
degrees.
Adjust the installation angle to less than 30 degrees.
The disc is dirty or defective. Clean the disc and try to play again or use new disc.
Cannot tune to radio
station, auto-seek does
not work
The antenna cable is not
connected.
Insert the antenna cable firmly.
The signals are too weak. Select a station manually.
Radio automatically
switches to WB (Weather
Band)
This is a normal function. A Weather
Band warning is being received.
If you do not want this to occur, set the WB Alert setting
to “Off” in the System Setup menu.
Radio automatically turns
on (ignition on) and tunes
to WB (Weather Band)
This is a normal function when the
Alert Power feature is set to “On” in
the System Setup menu. A Weather
Band warning is being received.
If you do not want this to occur, set the Alert Power
setting to “Off” in the System Setup menu.
Radio mutes audio when
vehicle is in reverse gear.
It is a normal function for the audio to
mute when the vehicle is backing up.
If the camera has a microphone, the camera audio will
be played when in reverse gear.

Other manuals for Jensen JRV212T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jensen JRV212T and is the answer not in the manual?

Jensen JRV212T Specifications

General IconGeneral
BrandJensen
ModelJRV212T
CategoryCar Receiver
LanguageEnglish

Related product manuals