Jet 16-32 Plus Operating Instructions And Parts Manual

6
Introduction
This manual is provided by JET covering the safe operation and maintenance procedures for a JET
Model 16-32 Plus Drum Sander. This manual contains instructions on installation, safety precautions,
general operating procedures, maintenance instructions and parts breakdown. This machine has been
designed and constructed to provide consistent, long-term operation if used in accordance with
instructions set forth in this manual. If there are any questions or comments, please contact either your
local supplier or JET. JET can also be reached at our web site: www.jettools.com.
Specifications
Stock Number.............................................................................................................................. 629004K
Model Number .......................................................................................................................... 16-32 Plus
Maximum Sanding Width (in.) ............................................................................................32 (two passes)
Minimum Sanding Length (in.) ........................................................................................................... 2-1/4
Maximum Thickness (in.) ......................................................................................................................... 3
Minimum Thickness (in.) .................................................................................................................... 1/32*
Overall Dimensions (HxWxD)(in.) ..................................................................................... 48 x 35 x 24-3/4
Drum Dimensions (dia.x L)(in.) ......................................................................................................... 5 x 16
Drum Speed (RPM) ........................................................................................................................... 1720
Drum Bearing Diameter (in.) .................................................................................................................... 1
Dust Port Diameter (in.) ........................................................................................................................... 4
Conveyor Motor ..................................................................................... 43-in.-lbs. torque, direct drive, DC
Conveyor Variable Feed Rate (SFPM) .................................................................... 0 to 10 (SandSmart™)
Drum Motor ......................................................... TEFC Induction, 1.5HP (1.1kW), 1PH, 110V, 14A, 60Hz
Noise emission (20in. from drum carriage)
1
............................... 73 dB (without load); 80-88 dB (with load)
Net Weight (lbs.) .................................................................................................................................. 164
* Note: Use of a carrier or backer board (not provided) is recommended for cuts 1/16” or less. See note on page 20.
1 The specified values are emission levels and are not necessarily to be seen as safe operating levels. As workplace
conditions vary, this information is intended to allow the user to make a better estimation of the hazards and risks
involved only.
The specifications in this manual were current at time of publication, but because of our policy of
continuous improvement, JET reserves the right to change specifications at any time and without prior
notice, without incurring obligations.

Jet 16-32 Plus Specifications

General

Maximum Board Width	32"
Dust Port Diameter	4"
Feed Rate	0-10 FPM
Voltage	115V
Sanding Capacity (Thickness)	3 inches
Abrasive Width	16 inches
Drum Speed	1725 RPM