8
Unpacking
Open boxes and check for shipping damage.
Report any damage immediately to your
distributor and shipping agent. Do not discard
any shipping material until the Drum Sander is
assembled and running properly.
Compare the contents of your boxes with the
following parts list to make sure all parts are
intact. Any missing parts should be reported to
your distributor. Read this instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of Boxes
Box #1: (see Figure 2)
1 Drum Head Assembly (A)
1 TUFTool
TM
(B)
1 Knob (C)
1 Depth Gauge Label (D)
4 Hex Washer Head Bolts, 5/16”x3/4” (E)
1 Box of Ready To Wrap
TM
Abrasives (G)
1 Instruction Manual (not shown)
1 Warranty Card (not shown)
Box #2: (see Figure 3)
1 Stand Assembly including:
4 Legs (H)
1 Shelf (J)
2 Long Rails (K)
2 Short Rails (L)
4 Leveling Feet (M)
1 Bag of Fasteners including:
24 Carriage Bolts, 5/16”x5/8” (N)
24 Flanged Lock Nuts, 5/16” (O)
8 Hex Nuts, 3/8” (P)
8 Flat Washers, 3/8” (R)
1 Conveyor Bed (S)
Read and understand the
entire contents of this manual before
attempting set-up or operation! Failure to
comply may cause serious injury.
Figure 2 – (Box #1)
Figure 3 – (Box #2)
To Next Page
Loading...
Need help?
General
