To Next PageTo Next PageWhy is there no coolant flow in my Jet HVBS-712?
If there is no coolant flow in your Jet Saw, it could be due to: * Coolant level low: Add coolant to tank. * Filter screen clogged: Clean filter screen. * Pump motor faulty: Replace pump.
How to fix inaccurate miter cuts on a Jet Saw?
Inaccurate miter cuts on your Jet Saw may be due to: * Improper setting of vise jaws: Use adjustable square or protractor to verify angle settings. * Blade worn; cutting crooked: Replace blade.
General| Motor Power | 1 HP |
|---|---|
| Voltage | 115/230V |
| Phase | 1 Phase |
| Round Capacity (90 Degrees) | 7 inches |
| Rectangular Capacity (90 Degrees) | 7 x 12 inches |
| Round Capacity (45 Degrees) | 4-1/2 inches |
| Style | Horizontal/Vertical Bandsaw |
| Blade Size | 93-1/2 x 1/2 in. |
Lists components included in the shipping carton.
Lists necessary tools for assembling the band saw.
Instructions for unpacking and initial cleaning of the machine.
Step-by-step guide for assembling the band saw components.
Details on preparing the coolant tank for use.
Essential guidelines for properly grounding the band saw.
Procedure for converting the machine's voltage.
Recommendations for using extension cords with the band saw.
Lists tools needed for making machine adjustments.
Instructions for adjusting the vertical position of the saw bow.
Guide to adjusting the band saw blade speed settings.
Instructions for adjusting and setting the blade guide assemblies.
Step-by-step process for replacing the band saw blade.
Details on adjusting the blade guide bearings for optimal performance.
Information on adjusting and maintaining the chip brush.
Procedure for setting and checking blade tension.
Instructions for adjusting the blade tracking for proper alignment.
Method for verifying adjustments using test cuts.
How to adjust the feed rate for efficient cutting.
Guidance on adjusting the counterbalance spring.
How to ensure the blade is perpendicular to the table for straight cuts.
Adjusting the automatic shut-off feature.
Instructions for positioning the vise for different cuts on the 712D model.
Instructions for positioning the vise for different cuts on the 712 model.
Procedure for breaking in a new saw blade.
Overall steps for operating the band saw safely and effectively.
How to assess cutting efficiency by observing chips.
Details on lubricating various parts of the machine.
Maintaining the correct coolant level for optimal performance.
Information on when to seek professional servicing.
Common mechanical and electrical issues and their solutions.
Solutions for common operational issues encountered during use.
Exploded diagram of the bed and stand assembly for parts identification.
Exploded diagram of the bow assembly for parts identification.
Detailed list of replacement parts with index numbers and descriptions.
