Changing Blades
1. Disconnect the machinefrom the power
source.
2. Raise the saw arm to the vertical position and
lock in place by turning the hydrauliccylinder off.
3.
Remove the red blade guard assembly (A, Fig.
12) by removing two screws (B, Fig.12).
4.
Remove the brush assembly (C, Fig. 12) by
removing two screws (0, Fig. 12).
5. Loosen blade tension by turning the blade
tension knob counter-clockwise.
6. Carefully remove the old blade. Caution:
blade teeth are sharp. Handle with care.
7. Install the new blade by placing the blade
between blade guides first. Make sure the blade
teeth face the same direction as indicated on the
label found on the saw arm.
8. Place the blade around both wheels. Make sure
the blade edge rests near the wheel flange on
both wheels.
Fig.12
9
To Next Page
Loading...
