5. Place the saw arm in the horizontal position
again. Wipe out remaining oil with a rag.
6. Fill the gear box with approximately 3/4 pint of
90 weight gear oil.
7. Replace the gasket and cover. Fastenthe cover
with screws.
8. Connect machine tTthe power ~ource.
Maintenance
1. Keep all surfaces clean and free of rust, slag,
chips, and coolant build-up.
2. Do not use compressed air to clean the
bandsaw. Compressed air may force chips into
the guide bearings and other critical areas of the
saw.
3; Use a small paint brush or parts cleaning brush
to remove metal particles.
4. Wipe the saw down with a clean, dry cloth and
oil all unpainted surfaces with light machine oil.
5. Keep the blade guides clean and free of metal
chips.
6. Checkthe guide bearings frequently to make
sure they are properly adjusted and turning
freely.
Chip Cleaning Brush
It is very important that the blade cleaning brush be
properly adjusted and kept in good working order.
Replace the brush if it becomes damaged or worn
out. Blade life will be shortened severely if the brush
is allowed to go out of adjustment, becomes
damaged, or is worn out.
14
To Next Page
Loading...
Need help?
General
