~ WARNING
Read and understand the entire instruction manual before operating machine.
This machine is designed and intended for use by properly trained and experienced personnel
only. If you are not familiar with the proper safe use of bandsaws, do not use this machine
until proper training and knowledge has been obtained.
"Warning: For your own safety read instruction manual before operation saw"
(a)
(b}
(c)
(d)
(e)
Wear eye protection.
Do not remove jammed cut off pieces until blade has stopped.
Maintain proper adjustment of blade tension, blade guides, and trust bearing.
Adjust upper guide to just clear workpiece.
Hold workpiece firmly against table.
1.
2.
Keep guards in place and in working order.
Remove adjusting keys and wrenches. Form habit of checking to see that keys and adjusting
wrenches are removed from tool before turning it on.
Keepwork area clean. Cluttered areas and benches invite accidents.
Don't use in dangerous environment. Don't use power tools in damp or wet locations, or
expose them to rain. Keepwork area well lighted.
Keep children away. All visitors should be kept safe distance from work area.
Make workshop kid proof with padlocks, master switches, or by removing starter keys.
Don't force tool it will do the job better and safer at the ratefor which it was designed.
Use right tool don't force tool or attachment to do ajob for which itwas not designed.
Use proper extension cord. Made sure your extension cord is in good condition.When using an
extension cords, be sure to use one heavy enough to carry the current your product will draw.
An undersized cord will cause a drop in voltage resulting in loss of power and overheating.
Table shows the correct size to use depending on cord length and nameplate ampere rating. If
in double, use the next heavier gage. The smaller the gage number, the heavierthe cord.
Wear proper apparel do not wear loose clothing, gloves, neckties, rings, bracelets, or other
jewelry which may get caught in moving parts. Nonslip footwear is recommended. Wear
protective hair covering to contain long hair.
Always use safety glasses. Also use face or dust mask if cutting operation is dusty. Everyday
eyeglasses only have impact resistant lenses,they are NOT safety glasses.
Secure work. Use clamp or a vise to hold work when practical. It is safer than using your hand
and it frees both hands to operate tool.
Don't overreach. Keep proper footing and balanceat all times.
Maintain tools with care. Keep tools sharp and clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
Disconnect tools before servicing; when changing accessories, such as blades, bits, cutters
and the like.
Reduce the rise of unintentionalstarting. Make sure switch is in off position before plugging in.
Use recommended accessories. Consult the owner's manual for recommended accessories.
The use of improper accessories may cause risk of injuryto person.
Some dust created by power sanding, sawing, grinding, drilling and other construction activities
contains chemicals known to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
. Lead from lead based paint
. crystalline silica from bricks and cement and other masonry products, and
. arsenic and chromium from chemically-treatedlumber.
Never stand on tool serious injury could occur if the tool is tipped or if the cutting tool is
unintentionallycontacted.
Check damaged parts. Before further use the tool, a guard or other part that is damaged
should be carefully checked to determine that it will operate properly and perform its intended
function - check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its operation. A guard or other part that is
damagedshouldbeproperlyrep~iredorreplaced.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
1
To Next Page
Loading...
Need help?
General
