EasyManuals Logo

Jet JJ-6CSDX User Manual

Jet JJ-6CSDX
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
27
13. To re-install the cutterhead, reverse the above
steps.
Note: Make sure that the fence base casting is
level with the Outfeed table when securing.
Lubrication
Use a good grade of light grease on the steel
adjusting screws located in the raising and
lowering mechanisms of the work tables.
Occasionally, apply a few drops of light
machine oil to the infeed/outfeed gibs. This
permits the tables to slide freely.
The cutterhead ball bearings are lifetime lubricated
and need no further care.
Figure 45

Other manuals for Jet JJ-6CSDX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jet JJ-6CSDX and is the answer not in the manual?

Jet JJ-6CSDX Specifications

General IconGeneral
BrandJet
ModelJJ-6CSDX
CategoryPower Tool
LanguageEnglish

Related product manuals