To Next PageTo Next PageWhy doesn't Jet JWBS-14SF table tilt hold position?
If the table tilt on your Jet Saw doesn't hold its position under load: * **Lock handle not tight:** Tighten the lock handle. * **Broken trunnion locking mechanism:** Replace the trunnion locking mechanism.
Why does Jet Saw blade form cracks at base of teeth?
If the blade on your Jet Saw is forming cracks at the base of the teeth: * **Unsuitable teeth:** Replace with a proper blade. * **Improper blade thickness:** Replace with a proper thickness blade. * **Incorrectly sharpened blade:** Sharpen the blade properly or replace it. * **Misaligned band wheels:** Contact a service representative.
What to do if Jet Saw table will not tilt?
If the table on your Jet Saw will not tilt: * **Trunnion not lubricated:** Lubricate the trunnion. * **Trunnion jammed:** Disassemble and replace the jammed parts.
What to do if Jet JWBS-14SF Saw blade cannot be tensioned properly?
If the blade on your Jet Saw cannot be tensioned properly: * **Tension spring is fatigued:** Replace the tension spring.
Dimensions and spacing for the band saw's base mounting holes.
Procedure for safely removing the band saw from its shipping container.
List of all parts and accessories included in the shipment.
Guidelines for selecting an appropriate and safe installation site.
Instructions for attaching the leveling feet to the machine base.
How to attach and use the table tilt adjustment handle.
Recommendations for connecting a dust collection system to the saw.
Guidance for safely connecting the band saw to a power source.
Essential safety procedures for proper electrical grounding.
Steps required to switch the saw for operation on different voltage supplies.
Advice on selecting and using appropriate extension cords.
Information on using the safety lockout feature for the power switch.
Lists the necessary tools for performing machine adjustments.
Instructions for installing and positioning the resaw fence plate.
Method for making precise fine-tuning adjustments to the fence.
How to align the table perfectly parallel to the saw blade.
Steps to ensure the fence is parallel to the saw blade for accurate cuts.
Procedure for leveling the table insert for a smooth cutting surface.
Adjusting the table's angle for bevel cuts, using the tilt scale.
Setting the positive stop to ensure a precise 90-degree table position.
Comprehensive guide for safely installing and changing saw blades.
Correct method for setting and adjusting the tension of the saw blade.
Procedure for aligning the blade to track correctly on the wheels.
Explanation of the purpose and function of blade guide bearing adjustments.
How to adjust the upper blade guides for proper blade support.
Setting the upper thrust bearing to support the blade.
Adjusting the lower blade guides for stability during cutting.
Steps for raising and lowering the guide post assembly.
Ensuring the guide post remains parallel throughout its travel.
Instructions for replacing and adjusting the drive belt tension.
Maintenance procedures for the wheel housing brushes.
How to safely start and stop the band saw's motor.
Standard steps to follow before and during operation.
Technique for cutting wood lengthwise along the grain.
Technique for cutting wood across the grain.
Method for slicing wood to create thinner boards.
Causes and solutions for the saw blade drifting off the cut line.
Identifying specific areas that require lubrication for smooth operation.
A chart providing recommendations for blade pitch, type, and feed rate.
Solutions for issues related to the band saw's operation.
Troubleshooting guide for mechanical and electrical faults.
Exploded diagram illustrating the components of the upper wheel assembly.
Exploded diagram showing the lower wheel and motor assembly parts.
Exploded diagram of the table and optional miter gauge assembly.
Exploded diagram detailing the components of the blade guide system.
A comprehensive list of all part numbers and descriptions for the band saw.
General
